Ouellet OHY User Manual download pdf (Page 2)

RECESSED WALL MOUNTING:

Keep a clearance of 1219 mm (48 in.) minimum in front

of heater and 25 mm (1 in.) to any walls.

RECESSED WALL MOUNTING STEPS:

1. Make a hole within the wall at least 70 mm (2 3/4 in.) of depth.

Recommended installation height is 305 mm (12 in.) below heater.

The hole must be 473 mm (18 5/8 in.) by 340 mm (13 3/8 in.);

use the template provided with the heater. CAUTION: HOLE

MUST BE CUT PRECISELY.

2. Remove front cover by unscrewing both screws at the bottom.

3. Remove the junction box cover by unscrewing the screw. Note

the plastic connector secured inside the junction box will be

connected outside the box once the heater is fully installed.

This connector links the enclosure with the display located on

the front cover.

4. Remove the inside module to which the fan is fixed

by loosening the four (4) RED screws.

9. Replace junction box cover and remove the front cover

from its protective bag.

10. Fix the plastic connector on the outlet located in the top

of the front cover.

11. Put front cover back making sure the cable linking the cover

with the heater does not get stuck. Test the heater to insure

control works properly.

2" (305 mm)

ecommended

" (102 mm)

inimum

2 3/4" (70 mm)

KOE Ø7/8”

P2/N

L2/N

Option

Disconnect

Load 2

FAN2

COM

LOAD1

LOAD2

FAN1

Hi-Limit

Power Base

P2/N

250 °F

121 °C

Load 2 = 1000W (240V), 500W (120V)

Load 1 = 1000W (240V), 1000W (120V)

OHYU only

OHY1502/2000

OHYU1502/2000

Load 1

5. Use the appropriate knock-out hole (KOE 7/8 in.) within the

junction box as well as the 6.35 mm (1/4 in.) knock-outs (item A

in the figure) located on each side of enclosure that will be used

to fix it to the wall. Run the power cable inside the enclosure.

6. Fix the enclosure by using the 6.35 mm (1/4 in.) knock-outs or

the holes on the back (indicated as item B in the figure) to firmly

fix the heater with provided screws (two additional longer screws

are provided to help in case of larger framing). DO NOT FIX THE

HEATER WITH THE HOLES MENTIONNED IN STEP #4 USED

TO SCREW THE INSIDE MODULE; THIS MAY CAUSE THE

HEATER TO MALFUNCTION.

7. Put inside module back and tighten the four (4) RED screws.

8. Wire the heater according to national and local codes and along

instructions marked on heater.

Keep this instruction pamphlet for the user.

INS101-200702-01

1 2 3 4

Comments to this Manuals

No comments

Ouellet OHY User Manual Page 2

Comments to this Manuals

Related products and manuals for Water boiler Ouellet OHY